Concrete Crack Repair

Panther - Specialists in Pressure Epoxy Injection for Permanent Concrete Crack Repairs for over 20 years. It's often repaired by just filling the crack with hydraulic cement, but to ensure it doesn't fail again, contractors should look for a solution that goes one step further and strengthen the whole area with carbon fiber crack repair that will reinforce the stair step crack in all directions.
Injected more than 1,000 linear feet of cracks in 14" thick taxiway. If this stress exceeds the strength of the concrete, cracks will form even where initial cracks did not exist (even after Epoxy Injection Crack Repair repair of these initial cracks). BBR Contech was the first company to introduce epoxy injection of concrete to New Zealand in the mid 1970s, using pumps and technology developed in Europe.
The injected epoxy typically cures within 5 hours and bonds the two sides of the crack together in addition to filling the crack through the entire thickness of the foundation wall (typically 8″), thereby sealing the crack permanently because the crack essentially no longer exists; this is the ultimate concrete crack repair.

If you notice flow problems, it may be connected to the French drain; we repair and replace the drains around your foundation and also do the periodic pressure cleaning which assures you a maximum quality of drainage by eliminating the residues of earth, mud or ferrous ocher in the drain.
Place the sand in the crack to a level no more than 1⁄4" thickness of the member and apply the injection epoxy as described in step 2. The epoxy level will drop as it penetrates the sand, but should cure and provide a seal to the bottom of the crack.

The epoxy mixture is a liquid, which contributes to several of the problems when using it to fill foundation cracks. This is advantageous to assure time for the epoxy to flow and fill even the smallest openings of a crack. When filling wide cracks, wait some time, not a lot, ensuring that the epoxy is filling the concrete crack.
The kit uses the very same materials our professional contractor customers use to fix concrete cracks in basements, retaining walls, sewers and manholes. 7- Maintain the ports at least for 48 hours to make sure the concrete crack is sealed. The best way to fix concrete wall cracks is to inject them with polyurethane, epoxy works also but it is much harder to inject.

Repair cracked concrete beams are investigated. Polyurethane foams are injected into the basement crack in a liquid form. NextStar concrete crack repair products used to repair poured foundation cracks. However, the urethane injections can only be applied to small cracks.
For more information on our epoxy pressure injection and chemical grout services, contact us for a quote today. Step # 1: The ports of plastic injection are joined with specific epoxy directly n the cracks. If epoxy is injected while the crack is leaking, the water seepage may actually create channels through the epoxy, creating leaks in the new repair.
The epoxy is then injected under pressure, using specialised equipment. Proper sealing of crack surface is necessary to avoid losses during injection. Contech is able to customize properties of the materials based on repair variables such as temperature, breadth and depth of the void, set time, and strength.

Rely on our epoxy injection company to see that the repairs are made quickly. Building up our strength in concrete repairs. Slab is a water-based acrylic latex caulk for concrete crack repair. The injected foam expands 20 times its volume after interacting with water to seal off all voids from front to back.

Leave a Reply

Your email address will not be published. Required fields are marked *